Solenoid Valve Manufacturer Hydralectric Solenoid Valve Range

SOLENOID VALVE MANUFACTURER

Our range of fully customisable solenoid valves are designed to ensure the safe transport, distribution and control of water.

PILOT OPERATED SOLENOID VALVES

Pilot Operated Plastic Body Solenoid Valves are compact normally closed solenoid valves offering basic ON/OFF functionality and are specifically designed to provide safe conveyance and control of water in systems with inlet pressure from 0.2-10bar. Ideally suited for use in a wide range of appliances and equipment. Hydralectric is a leading solenoid valve manufacturer in the UK.

The range is available with the following approvals : WRAS , NSF, UL/ CSA and ENEC.

Datasheet

DIRECT ACTING SOLENOID VALVES

Direct acting solenoid are independent of the incoming water pressure using a diaphragm directly linked to the armature. When the coil is energised the armature lifts the seal from valve orifice thus allowing flow through the valve. They are supplied normally closed and provide effective on/off control of the liquid under low pressure applications typically less than 0.2 bar.

The range is available with the following approvals : WRAS , NSF , UL/CSA and ENEC.

Datasheet

LATCHING/BI-STABLE SOLENOID VALVES

Latching solenoid valves, also referred to as bi-stable solenoid valves uses a permanent magnet attached to the armature, when energised with short 250msec 6 volt pulse the armature is forced into either open or closed state depending on the signal polarity. They provide effective on/off control of water services ranging from 0.2 – 10bar where a constant supply of electrical power is either not appropriate or available.

The range is available with the following approvals : WRAS , NSF , & UL/CSA.

Datasheet

PROPORTIONAL SOLENOID VALVES

The Proportional Solenoid Valve offers the same On/Off control as standard Pilot-Operated Solenoid Valves but with the added functionality to control the flow of water passing over the valve orifice. Proportional control is offered across hot and cold water supplies from 0.5 up to 12 litres per minute within dynamic pressure range from 0.5-10 bar.

The valve can be controlled using 24VDC power supply or pulse width modulated signal to provide variable control when used in closed loop systems.
Hydralectric is a leading UK proportional valve manufacturer.

SERVO ASSISTED SOLENOID VALVES

The Servo operated pilot valve is designed for low power 12VDC supplies with maximum 3 watts. The valve utilises a unique servo system which in turn decreases the power required whilst maintaining control of water supplies from 0.2 to 10bar.

The range is available with the following approvals : WRAS , NSF , & UL/CSA.

Datasheet

BESPOKE SOLENOID VALVES

Hydralectric have the capabilities to help develop bespoke valve solutions to meet your exact specification. Unique valve body design available in all voltages and flow requirements. Our R&D department can work with you from concept design through to manufacturing.
Hydralectric is a leading solenoid valve manufacturer in the UK.